50MM-600MM 8000N Heavy Duty Linear Actuator C One-Control-Two Synchronous Control Kit (Model 0043053-1)

50MM-600MM 8000N Heavy Duty Linear Actuator C One-Control-Two Synchronous Control Kit (Model 0043053-1)This one control two synchronous kit is used for heavy duty linear actuators to synchronize their operation. It contains two Type C heavy duty actuators with built in Hall effect sensors, one synchronous controller, one touch control handle, and a CH 3 remote control. Note: All linear actuators must be connected to the synchronous controller for the system to function properly. The synchronous controller has two selectable external control functions,

you can connect two external limit switches with normally open contact (such as model 0010010) to this controller and then automatically stop the linear actuators through it

With limit control terminals: You can connect limit switches or sensors to stop the motor

It boasts high speed capabilities

When motor rotates in reversal direction

Two selectable control modes: Interlocking mode or Momentary mode

You can operate two motors to rotate in positive or reversal direction by using the buttons in the receiver or by the transmitter

resulting in a retraction length of 290 mm

so motor's maximum starting current can not exceed 30A

resulting in a retraction length of 605 mm

Press and hold the button ▼ on the remote: linear actuator inward retracts

a specified retraction length of 1200 mm is less than the standard retraction length of the ordered actuator (1250 mm)

which is twice as much as it used to be