T-Rex Engineering Vulture Distortion

T-Rex Engineering Vulture DistortionIMPROVING DISTORTION The Vulture started its life, when Michael plugged in one of the very first pedals we made. That pedal had a certain sound to it that we really liked, but it was a bit grungy in the low end. We wanted to make a pedal with that sound, but with a tighter, less fuzzy low end and with more gain. We opened up the pedal and painstakingly measured everything in it, to find out why it sounded so good, and found a couple of resistors that

The problem is solved: if the pre loop is not engaged the amplifier will only see the pure guitar signal without it going through any switches or relays

It is equally at ease in both lead and rhythm capacities

Amp / Mixer mode optimizes 1/4" outputs for amps and mixers

Also featured are a texture knob to adjust the tone of the reverb signal

these outputs will accommodate almost any pedal

EXP MODES or 8 Presets

TOTAL CONTROL

There's an internal drive/gain trimmer and a tone trimmer

recording and home practice

Channels: 2

We created the Venue DI so you can travel light

this pedal delivers