Electric Linear Actuator A Fixed Mounting Flat Base (Model 0043070)

Electric Linear Actuator A Fixed Mounting Flat Base (Model 0043070)Fixed mounting flat base for electric linear actuator A Aluminum material. Can be used to replace the linear actuator A bottom mounting bracket. Can be used for vertical mounting linear actuators A Installation operation: 1. Use a hexagonal wrench to unscrew the three screws at the bottom of linear actuator A and remove the original bottom shell. 2. Install the flat base to the bottom of linear actuator A and tighten the three screws with a hexagonal

Plug the linear actuators into into the corresponding channel terminal of the controller

000 cycles Power Cable Ordinary two-core wire (Normal actuators)

you can also choose to retain the original standard retraction length of 975 mm

For 4 Linear Actuators C / F with Hall effect sensors)

then the motor rotates reversal direction

5~3A at 24V Recommended Power Supply 12V/6A or 24V/3A Shaft Diameter 20mm [0

Channel: 1 CH

E13: Hall signal of linear actuator 4 is abnormal

Operation with linear actuator:1) Press and hold the "Up" button

the relay 2 is activated

3) Push the handle to another position <ON>

Setting single signal trigger delay working mode: