Quick change tapping chuck HSK 40 - M3-M12

Quick change tapping chuck HSK 40 - M3-M12Application: For the chucking of quick change adaptors for taps. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Upon switching on the display will read the actual absolute measuring position

Ergonomic Handle of Design

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

For mounting the coolant tubes in HSK toolholders

For machining centres without synchronous spindle

For setting the tool in the HKS collet chucks

For individual combination of T-bolts in conjunction with T-nuts and tenons

E2= 20 pieces

- Auto/manual shutdown

cartide tipped measuring sufaces

quantity of inserts:

With retaining screw