Shrink chuck 4,5° with cooling channels SK 50 - 14 - 80

Shrink chuck 4,5° with cooling channels SK 50 - 14 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

driving ring and feather key

without cooling lubricant supply

Without wrench

clamping depth

cross head retaining screw and cylinder head retaining screw for cutters with central coolant

(applicable up to 21 bar)

Only nominal size d can be clamped with sealing plug for internal cooling (applicable up to 21 bar) In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet

For mounting tools with Morse taper shank and tang according to DIN 228-1 form B

Collection of collets

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance6

For clamping tools with Morse taper shank and thread according to DIN 228-1 form A

Retaining screw for mounting of face mills arbors